-
Notifications
You must be signed in to change notification settings - Fork 970
Troubleshooting
Candas1 edited this page May 31, 2023
·
34 revisions
The board is not turning ON, you can't hear the power stage buzz noise, there is no melody, the led on the mainboard is OFF
- the top TIP127 mosfet might be defective (Q2 in schematics)
The board is not turning ON, you hear the power stage buzz noise, there is no melody, the led on the mainboard is OFF
- Can happen if you haven't flashed the chip properly, make sure you hold the button while flashing so the chip is always powered
- The chip might be defective, can you connect to it with st-link utility while keeping the button pressed? Even if you feed the board with 3.3v from the st-link ?
- The 5v or 3.3v dc-dc converters could be defective, you can usually find the same dc-dc converters on the sideboards
- If the board draws more than 100mA in idle, it's probably broken
The board is not turning ON, you hear the power stage buzz noise, there is no melody, the led on the mainboard is ON
- If the led on the mainboard is ON when you press the button, but the board doesn't stay ON when you release the button, you might want to check if you have another variant of the board
The board is turning ON as soon as the battery or charger is connected, and there is a continuous beep after the melody when you try to turn it OFF
- The top TIP127 mosfet is probably shorted (Q2 in schematics). Use a multi-meter to check the continuity between drain and source. If your multi-meter beeps, the mosfet is shorted so you need to replace it
- It can happen when the battery voltage is too low
- It could be at least 2 mosfets of the same half-bridge/phase are shorted. Use a multi-meter to check the continuity between drain and source. If your multi-meter beeps, the mosfet is shorted so you need to replace it
- Check this section
- Make sure all option bytes are checked in st-link utility
- Check the Battery troubleshooting section
- Check Diagnostics section
- Please also check in the Wiki the troubleshooting section of the variant you are using
The board turns ON, there is no double beep after the Power On melody, there are no error beeps, wheels are not spinning
- Make sure you did proper Auto-Calibration
- Don't use a jumper wire instead of the ON/OFF button, firmware will run only when this input is released
- You board might have phases/hall wires mapped in a different way, check firmware compatibility section