Add stonith timeouts to overview table

xml/ha_installation_overview.xml

@@ -37,9 +37,9 @@
     </step>
     <step>
       <para>
-        You can set up the cluster with either the &rootuser; user or a user with
+        You can set up the cluster with the &rootuser; user or a user with
         <command>sudo</command> privileges. Review <xref linkend="cha-ha-log-in"/>
-        to determine the appropriate user for your requirements.
+        to choose the right user for your requirements.
       </para>
     </step>
     <step>
@@ -91,8 +91,8 @@
       </itemizedlist>
       <para>
         <xref linkend="tab-ha-installation-overview"/> shows the components that can be
-        configured by each method. You can also use a combination of both methods.
-        For example, you could set up one node with the &yast; cluster module, then use
+        configured by each method. You can also use a combination of methods.
+        For example, you could set up one node with &yast;, then use
         the bootstrap scripts to add more nodes.
       </para>
     </step>
@@ -185,6 +185,11 @@
           <entry>Optional (SBD only)</entry>
           <entry>No; configure after setup</entry>
         </row>
+        <row>
+          <entry>&stonith; timeout settings</entry>
+          <entry>Yes, if SBD is configured</entry>
+          <entry>No; configure after setup</entry>
+        </row>
         <row>
           <entry>Virtual IP address for &hawk2;</entry>
           <entry>Yes</entry>