Send: G28 X Y Z
Recv: echo:Active Extruder: 0
Recv: current_position[Z_AXIS] 0.00
Recv: Raise Z (before homing) to 10.00
[...]
Recv: echo:Active Extruder: 0
[...]
Recv: echo:Active Extruder: 0
[...]
Recv: echo:Active Extruder: 1
Recv: echo:Active Extruder: 0
Recv: X:-20.77 Y:-15.50 Z:11.08 E:0.00 Count X:-1664 Y:-1242 Z:11165
Recv: ok
Send: G29
[...]
Recv: Bilinear Leveling Grid:
Recv:  = [[ 10.000, 100.000, 190.000, 10.000, 100.000, 190.000, 10.000, 100.000, 190.000]  ,[ 0.000, 0.000, 0.000, 115.000, 115.000, 115.000, 230.000, 230.000, 230.000]  ,[ -0.052, -0.021, -0.173, -0.052, 0.003, -0.134, -0.019, 0.006, -0.163]];
Recv: X:169.00 Y:230.00 Z:11.20 E:0.00 Count X:13537 Y:18423 Z:11165
Recv: ok
Send: @BEDLEVELVISUALIZER
Send: M420 V
Recv: echo:Unknown command: "@BEDLEVELVISUALIZER"
Recv: ok
Recv: Bilinear Leveling Grid:
Recv:  = [[ 10.000, 100.000, 190.000, 10.000, 100.000, 190.000, 10.000, 100.000, 190.000]  ,[ 0.000, 0.000, 0.000, 115.000, 115.000, 115.000, 230.000, 230.000, 230.000]  ,[ -0.052, -0.021, -0.173, -0.052, 0.003, -0.134, -0.019, 0.006, -0.163]];
Recv: echo:Bed Leveling On
Recv: echo:Fade Height Off
Recv: ok
[...]
SendAutosc