| Part | Qty | Notes |
|---|---|---|
| HFSB5-2020-500-TPW | 3 | Part number is for ordering from Misumi |
| HFSB5-2040-235 | 6 | Part Number is for ordering from Misumi |
| Part | Qty | Notes |
|---|---|---|
| 200mmø x 5mm Aluminum Bed | 1 | MandalaRoseWorks / EU folks can ping @owl47_brunosilva on Discord |
| 200mmø PEI Sheet | 1 | Aliexpress |
| 200mmø Magnetic Sheet | 1 | - |
| M3 x 9mm Ball Screw | 3 | Aliexpress |
| 3 x 20mm Steel Dowel Pin | 6 | Aliexpress |
| Part | Qty | Notes |
|---|---|---|
| MGN9H 350mm Linear Rail and Carriage | 3 | Any length between 350mm and 400mm fits Aliexpress |
| GT2 Timing Belt 9mm | ~3 meters | Gates belts are recommended, do not use steel core Aliexpress |
| GT2 20T Idler 9mm | 3 | Aliexpress |
| 5 x 25mm Steel Dowel Pin | 3 | Aliexpress |
| GT2 20T Pulley 9mm | 3 | Aliexpress |
| Nema17 Stepper Motors (60mm maximum, 48mm recommended) | 3 | - |
| 210mm Fisheye Rods | 6 | I used: FLSUN Q5 arms Aliexpress |
| MR625 Bearing | 3 | Optional for Nema17 with shafts greater than 24+mm |
| Part | Qty | Notes |
|---|---|---|
| 200W 24V DC Power Supply | 1 | Meanwell UHP-200-24 Power Supply Aliexpress |
| 170mmø 200W AC Heater | 1 | Keenovo |
| IEC320 C14 Inlet | 1 | DigiKey |
| Solid State Relay | 1 | Omron SSR |
| MCU with 4+ stepper drivers | 1 | BTT SKR Pico / |
| Omron D2F-L microswitch | 3* | 3 is standard, 4 if you're using Klicky Probe |
Most hardware used throughout the design is button head
| Part | Qty | Notes |
|---|---|---|
| M3 x 6 | 40 | - |
| M3 x 8 | 110 | - |
| M3 x 10 | 12 | - |
| M3 x 12 | 10 | - |
| M3 x 16 | 26 | - |
| M3 x 20 | 2 | - |
| M3 x 30 | 2 | - |
| M5 x 8 | 24 | - |
| M5 x 10 | 26 | - |
| M5 x 12 | 36 | - |
| M5 x 16 | 3 | - |
| M5 x 25 | 6 | - |
| M5 Hex Nut | 3 | - |
| M3 Heat Inserts | 50 | - |
| Part | Qty | Notes |
|---|---|---|
| ACM/Acrylic Inner Panels | 2 | Viper Worx UK |
| ACM/Acrylic Bottom Panel | 1 | Viper Worx UK |
| ACM/Acrylic Upper Panel | 1 | Viper Worx UK |
| Acrylic Side Panels | 3 | Viper Worx UK |