STM32 Nucleo-H563ZI Board not recognized

[DF4OR]

Hi.
Beginner here.
I have sucessfully used other boards (e.g. Nucleo-F091RC) with the current st-link utils on Linux. The Nucleo-H563ZI board in contrast is not properly recognized and cannot be programmed.

Output of lsusb
Bus 003 Device 017: ID 0483:374e STMicroelectronics STLINK-V3

Output of st-info --probe

  version:    V3J10
  serial:     003A001B3132511138363431
  flash:      0 (pagesize: 0)
  sram:       0
  chipid:     0x000
  dev-type:   unknown

Outout of st-info --version
v1.8.0

System

• Arch Linux, kernel 6.8.1-arch1-1
• stlink utils installed with pacman

Any idea what's going on?

TIA,
Ekki

[Nightwalker-87]

I can verify this with the same hardware.
As far as I can see, support for this board/chip has not been (fully) implemented yet.

[Nightwalker-87]

Follow up in issue #1384.