Disabling brightness limiter requires additional changes before saving

[Fonzi03]

What happened?

Cannot save after disabling automatic brightness

To Reproduce Bug

If you go to LED Preferences and de-select "Enable automatic brightness limiter" and try to save without making any other changes you cannot save. Change any value anywhere else and you can save.

Expected Behavior

you should be able to save after changing a setting.

Install Method

Binary from WLED.me

What version of WLED?

2410270

Which microcontroller/board are you seeing the problem on?

ESP32

Relevant log/trace output

No response

Anything else?

No response

Code of Conduct

• I agree to follow this project's Code of Conduct

[softhack007]

As this affects the LEDs settings page, it would be good to understand what's going on before 0.15.0-RC1 #4287

[Fonzi03]

As this affects the LEDs settings page, it would be good to understand what's going on before 0.15.0-RC1 #4287

If you need me to test anything or provide more details I'm more than happy to do so.

[DedeHai]

I just tried this and and saving works.
@Fonzi03 did you try this on a fresh install or what is the history? Did you try clearing local browser storage?

[Fonzi03]

I just tried this and and saving works.
@Fonzi03 did you try this on a fresh install or what is the history? Did you try clearing local browser storage?

I don't remember if when this occured it was on a fresh install or not. I was having multiple different issues at the time and flashed a handful of times. If it can't be reproduced it's likely it was a secondary order issue.

I can test again but probably not for another week or so.

[dosipod]

If by "requires additional changes before saving" meaning it will not save unless you enter the "Maximum PSU Current" and next time also enter the "mA/LED" then yes we have reported that among others multiple times . Mostly in discord but I think it was seen as not important

Uploading pref_no_save.mov…

edit: Could not load video to this page for some reson , it is here
dosipod#1

[Fonzi03]

If by "requires additional changes before saving" meaning it will not save unless you enter the "Maximum PSU Current" and next time also enter the "mA/LED" then yes we have reported that among others multiple times . Mostly in discord but I think it was seen as not important

Uploading pref_no_save.mov…

Precisely the issue, except it's not limited to mA/LED you just have to change literally any other value on the page for it to them allow saving.

[dosipod]

Just to clarify as I had issue loading the video , in my test the issue is once you check the limiter so not the other way around , can you take a video of the issue so it is more clear