Setup70d_ILI9488_S3_Parallel.h

#define USER_SETUP_ID 146

#define TFT_PARALLEL_8_BIT

//#define ILI9341_DRIVER
//#define ST7796_DRIVER
#define ILI9488_DRIVER

// ESP32 S3 pins used for the parallel interface TFT
#define TFT_CS    9
#define TFT_DC    8  // Data Command control pin - must use a GPIO in the range 0-31
#define TFT_RST  34

#define TFT_WR    7  // Write strobe control pin - must use a GPIO in the range 0-31
#define TFT_RD    6

#define TFT_D0   12  // Must use GPIO in the range 0-31 for the data bus
#define TFT_D1   13  // so a single register write sets/clears all bits
#define TFT_D2   14
#define TFT_D3   15
#define TFT_D4   16
#define TFT_D5   21
#define TFT_D6    5
#define TFT_D7    4


#define LOAD_GLCD
#define LOAD_FONT2
#define LOAD_FONT4
#define LOAD_FONT6
#define LOAD_FONT7
#define LOAD_FONT8
#define LOAD_GFXFF

#define SMOOTH_FONT