Skip to content

Latest commit

 

History

History
106 lines (84 loc) · 3.98 KB

README.md

File metadata and controls

106 lines (84 loc) · 3.98 KB

Arilux AL-LC03 LED controller

Alternative firmware

Alternative firmware for Arilux AL-LC03 LED controllers, based on the MQTT protocol and a TLS connection. The LED controller is a cheap product commercialized by Banggood.com and can be easily reprogrammed.

Arilux

Features

  • Remote control over the MQTT protocol
  • Remote control over IR codes
  • TLS support

Demonstration

Arilux AL-LC03 + IR + MQTT + Home Assistant

Flash the firmware

Schematic

  • VCC (Arilux) -> VCC (3.3 [V])
  • RX (Arilux) -> TX (FTDI)
  • TX (Arilux) -> RX (FTDI)
  • GPIO0 (Arilux) -> GND (FTDI)
  • GND (Arilux) -> GND (FTDI)

Note: To enter in programming mode, you need to put GPIO0 to LOW while powering the board. It's not possible to reprogram the module without soldering the wire to the ESP8266 module.

ESP-12F layout: https://cdn.solarbotics.com/products/photos/ec129f72948c266ec1502ae5a4d514ba/29240-IMG_0808.jpg

The FTDI from the left gives power and it's connected to an USB charger (VCC, GND). The FTDI from the right is connected to the computer and is used to reprogram the ESP8266 (RX, TX, GND).

Layout

Settings for the Arduino IDE

Parameter Value
Board Generic ESP8266 Module
Flash Mode DIO
Flash Frequency 40 MHz
Upload Using Serial
CPU Frequency 80 MHz
Flash Size 512K (64K SPIFFS)
Reset Method ck
Upload Speed 115200
Port COMX, /dev/ttyUSB0, etc.

Control

IR

The LED controller can be controlled with the IR remote included with the Arilux AL-LC03. The functionalities Flash, Strobe, Fade and Smoothare not implemented yet.

MQTT

State

# Topic Payload
State arilux/state/state ON/OFF
Command arilux/state/set ON/OFF

Brightness

# Topic Payload
State arilux/brightness/state 0-255
Command arilux/brightness/set 0-255

Color

# Topic Payload
State arilux/color/state 0-255,0-255,0-255
Command arilux/color/set 0-255,0-255,0-255

Configuration for Home Assistant

configuration.yaml

mqtt:
  broker: 'm21.cloudmqtt.com'
  username: '[REDACTED]'
  password: '[REDACTED]'
  port: '[REDACTED]'

light:
  - platform: mqtt
    name: 'Arilux RGB Led Controller'
    state_topic: 'arilux/state/state'
    command_topic: 'arilux/state/set'
    brightness_state_topic: 'arilux/brightness/state'
    brightness_command_topic: 'arilux/brightness/set'
    rgb_state_topic: 'arilux/color/state'
    rgb_command_topic: 'arilux/color/set'

TODO

  • Flash
  • Strobe
  • Fade
  • Smooth

THE SOFTWARE IS PROVIDED "AS IS", WITHOUT WARRANTY OF ANY KIND, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO THE WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE AND NONINFRINGEMENT. IN NO EVENT SHALL THE AUTHORS OR COPYRIGHT HOLDERS BE LIABLE FOR ANY CLAIM, DAMAGES OR OTHER LIABILITY, WHETHER IN AN ACTION OF CONTRACT, TORT OR OTHERWISE, ARISING FROM, OUT OF OR IN CONNECTION WITH THE SOFTWARE OR THE USE OR OTHER DEALINGS IN THE SOFTWARE.

If you like the content of this repo, please add a star! Thank you!