-
Notifications
You must be signed in to change notification settings - Fork 6
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
Unable to read tmc uart 'gear_stepper' register IFCNT #5
Comments
After long search this seems to be issue of Klipper, and not TMC driver |
Is there a fix, or do you have a reference that shows that this is a Klipper problem instead of an ERB hardware issue? |
I just updated and now have the same issue. Has anyone found a fix yet? |
I ended up just throwing it out. Turns out there's a lot more wrong with the design than just the complete failure of the microcontroller. The on board power supply is under powered too, so there's no point in actually using this board. |
Hi,
I have just installed the ERCF with ERB v1.1 board, flashed the RP2040 with newest klipper:
mcu ercf(rp2040) Version: v0.11.0-241-gffb5105b Load: 0.00, Awake: 0.00, Freq: 12 MHz,
After I try to move with one of the motors, I always got this error (lines are from klippy.log):
`TMC gear_stepper failed to init: Unable to read tmc uart 'gear_stepper' register IFCNT
klippy (1).zip
Is the wrong hardware or do I miss somethink else in the config?
The text was updated successfully, but these errors were encountered: