custom_postgui.hal

# Include your customized HAL commands here
# The commands in this file are run after the AXIS GUI (including PyVCP panel) starts

# set up the rapid to home button
 net remote-rapid-to-home     halui.mdi-command-00    <= pyvcp.rapid-to-home
 net remote-rapid-to-home-xy  halui.mdi-command-01    <= pyvcp.rapid-to-home-xy
 net remote-go-away-xyz       halui.mdi-command-02    <= pyvcp.go-away-xyz
 net remote-recenter          halui.mdi-command-03    <= pyvcp.recenter
 net remote-find-center       halui.mdi-command-04    <= pyvcp.find-center
 net remote-rect-center       halui.mdi-command-05    <= pyvcp.find-rectangle-center
 net center-here-xyz          halui.mdi-command-06    <= pyvcp.center-here-xyz
 net set_z                    halui.mdi-command-07    <= pyvcp.set_z
 net probe                    parport.0.pin-11-in-not <= pyvcp.probe

# set up spindle speed control
 net spindle-cmd-rpm-abs    => pyvcp.spindle-speed
 sets spindle-at-speed true

# 3D probe
 net 3D_probe arduino.probe_3d <= pyvcp.probe_3d


# Temperature
 #net water_temp arduino.temperature => pyvcp.temperature 

# Timer 
 loadrt time
 loadrt not
 addf time.0 servo-thread
 addf  not.0 servo-thread
 net prog-running    not.0.in           <= halui.program.is-idle
 net cycle-timer     time.0.start       <= not.0.out
 net cycle-seconds   pyvcp.time-seconds <= time.0.seconds
 net cycle-minutes   pyvcp.time-minutes <= time.0.minutes
 net cycle-hours     pyvcp.time-hours   <= time.0.hours

#Time estimantion 
 net time-minutes-sim pyvcp.time-minutes-sim <= axisui.cut_time