customizable END_PRINT, similar to START_PRINT

[teookie]

Describe the feature or hardware support you'd like

Would be great if custom modules could be called in the end_print macro.

Additional context or information

No response

[Surion79]

how many would you like and where should they be placed? It is a bit more than just adding some custom calls. it would require some sort of endprint_actions like for start print

[github-actions]

📌 This issue has been marked as stale because it has not had activity in the past 30 days.
To keep it open, please respond to this message or add new information. Otherwise, this will be closed in 14 days.
Thank you for your contributions!

[Surion79]

@Frix-x is there a need for this? it seems a bit like a bigger implementation

[rajenki]

@Surion79 I'd love this as well. 3 custom actions for end and cancel print seems great, similar to start print (including endprint_actions/cancelprint_actions).

[Surion79]

before implementing something like that I require more input:
which macro commands in endprint should be put in which submodules for endprint?
it needs to be divided sufficiently so stuff can be excluded by being removed from endprint_actions.

[rajenki]

I'm relatively new to Klippain still, so I'm probably not the best person to advise, but if you're asking how to break up the end/cancel print macros, I'd say the existing blocks (retract, turn off heaters, tach check, mesh clear, disable motors, filter, lights, reset filament sensor) would be a good start?

[jonathandann]

I'd like to be able to customise a (safe) x_y_z travel (including speed) so the toolhead can move away quickly from the park to avoid stringing. Similar to the move defined in https://github.com/VoronDesign/Voron-2/blob/Voron2.4/firmware/klipper_configurations/SKR_1.4/Voron2_SKR_14_Config.cfg#L574

This might workable enough as some variables, instead of a full-blown action as in print_start.

[github-actions]

📌 This issue has been marked as stale because it has not had activity in the past 30 days.
To keep it open, please respond to this message or add new information. Otherwise, this will be closed in 14 days.
Thank you for your contributions!

[LuisWinter]

I would like something like this as well, or alternatively, have skew profiles in the base macro.

[github-actions]

📌 This issue has been marked as stale because it has not had activity in the past 30 days.
To keep it open, please respond to this message or add new information. Otherwise, this will be closed in 14 days.
Thank you for your contributions!