Acceleration issue #1744
datibi
started this conversation in
General Discussion
Replies: 1 comment
-
Meh, ignore it, i just found out in the sourcecode that it takes commands up to 20000mm accelerations, and i tested with a print.... so it's fine as is... Please close it. |
Beta Was this translation helpful? Give feedback.
0 replies
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
-
Hi, on ender 3v2 jyersui fw I noticed that acceleration does not go above 1000 and the hardware is clearly capable doing it, it's able to print flawlessly with jerk set to 50 in cura, the whole printer flexes but the steppers do not skip. Also it does not take values above around 2000. Please change limit to 20000, should be able to handle it without any issue.
Thank you!
Beta Was this translation helpful? Give feedback.
All reactions