-
-
Notifications
You must be signed in to change notification settings - Fork 1.7k
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
Sometimes Lqi problem after pairing a new device ( CC2652R zzh stick) #6837
Comments
The LQI feature is something that has to be supported by the device, not all devices may do this (I believe e.g. gledopto devices don't) |
Hi, Hi don't have gledopto devices. All my switch are xiaomi devices( xiaomi switchs, water sensor, smart plugs, door sensor, vibration sensor, smoke detector, motion detector...) and philips hue bulbs. |
Could you provide the debug log of this? See https://www.zigbee2mqtt.io/information/debug.html on how to enable debug logging. |
Ok i will test. But in order to see the log file , how i get the file? In the information appears: Important: this is not logged to the log files and is only available on the STDOUT. What o where is STDOUT? Thanks |
Only the herdsman debug logging is logged to stdout. I don't need the herdsman debug logging, just the normal one which is logged to the log files. |
Dear friend, I have enabled the log_level: debug line in configuration.yaml below advanced. I have added 2 devices today but now both lqi are OK. As the failure does not always occur, I will try every day until the lqi errors occur, then I will send you the log. Thank you. |
Dear @Koenkk , Due to enrolling 2 new devices "0x00158d0006a28b66" and"0x00158d0006b635c9", they appear without a line drawn in the network map I removed the devices and again added them back to the network but the error Failed to execute LQI for 'Router plug' is shown several times. after retrying this several times I get satisfactory lqi.
I think that when the lqi error appears the device appears without lines drawn on the network map. I leave below the record that I request. thanks in advance
|
Confirmed with a vengeance :) The only time I see this issue is with GLEDOPTO devices and I have many. |
This issue is stale because it has been open 30 days with no activity. Remove stale label or comment or this will be closed in 7 days |
Any improvement? Thanks in advanced |
This issue is stale because it has been open 30 days with no activity. Remove stale label or comment or this will be closed in 7 days |
What happened
Sometimes after pairing a new device appear the following error lines:
the problem is solved unplug and plug again the lqi device. In my case 'Denon Plug' Im my network de Denon Plug is a plug but also a repeater plug. I habe two plug repeaters, some times the other repeater plug also get the same lqi error.
What did you expect to happen
Pairing all devices withouth lqi errors in the network. it is cumbersome to unplug the repeaters every time we pair a new device
How to reproduce it (minimal and precise)
Sometimes pairing a new device. Sometimes works fine
Debug info
Zigbee2MQTT version: "version":"1.18.1-dev"
Adapter hardware: CC2652R zzh
Adapter firmware version: revision":20210120
The text was updated successfully, but these errors were encountered: