Arm Support

[Penagwin]

Could I get an overview on roughly how to setup marlin on the re-arm or the due? Which would be better, the re-arm? Is this a viable setup right now (Stable)?

There are a ton of branches and I don't know which is best. I'm sorry for the dumb questions.

[fiveangle]

It is still under very active development with Re-ARM most current. Please close this issue and review thse threads #7121, #7076, #7622, #7511, #6524, #7028 (comment), #7264

Welcome aboard ! :)

-=dave

[Bob-the-Kuhn]

The Re-ARM code isn't ready for prime time yet. Some people have reported success, others have had problems. You'll need to use PlatformIO to compile the code.

For the Due you should be able to compile Marlin 1.x using Arduino.

There's also the MK4duo fork. It's basically Marlin 1.x but with an online configuration tool. It works nicely for most printers. There are definitely option combinations that it doesn't support.

If you need 6 stepper drivers then a Due and the RAMPS-FD is a nice combo.

[github-actions]

This issue has been automatically locked since there has not been any recent activity after it was closed. Please open a new issue for related bugs.