README.DNS64

The DNS64 code was written by Viagenie, 2009, by Simon Perrault as part
of the Ecdysis project.  The code is copyright by them, and has the BSD
license (see the dns64/dns64.c file).

To enable DNS64 functionality in Unbound, two directives in unbound.conf must
be edited:

1. The "module-config" directive must start with "dns64". For example:

    module-config: "dns64 validator iterator"

If you're not using DNSSEC then you may remove "validator".

2. The "dns64-prefix" directive indicates your DNS64 prefix. For example:

    dns64-prefix: 64:FF9B::/96

The prefix must be a /96 or shorter.

To test that things are working right, perform a query against Unbound for a
domain name for which no AAAA record exists. You should see a AAAA record in
the answer section. The corresponding IPv6 address will be inside the DNS64
prefix. For example:

    $ unbound -c unbound.conf
    $ dig @localhost jazz-v4.viagenie.ca aaaa
    [...]
    ;; ANSWER SECTION:
    jazz-v4.viagenie.ca.        86400   IN      AAAA    64:ff9b::ce7b:1f02


NAT64 support was added by David Lamparter in 2022; license(s) of the
surrounding code apply.  Note that NAT64 is closely related but functionally
orthogonal to DNS64;  it allows Unbound to send outgoing queries to IPv4-only
servers over IPv6 through the configured NAT64 prefix.  This allows running
an Unbound instance on an IPv6-only host without breaking every single domain
that only has IPv4 servers.  Whether that Unbound instance also does DNS64 is
an independent choice.

To enable NAT64 in Unbound, add to unbound.conf's "server" section:

    do-nat64: yes

The NAT64 prefix defaults to the DNS64 prefix, which in turn defaults to the
standard 64:FF9B::/96 prefix.  You can reconfigure it with:

    nat64-prefix: 64:FF9B::/96

To test NAT64 operation, pick a domain that only has IPv4 reachability for its
nameservers and try resolving any names in that domain.