You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
ssc338q (infinity6e family), imx415, 16 MB nor flash, 2.4.09.05-lite, openipc-ssc338q
If you select several regions in the visual editor, then motion detection and the call of the script motion.sh does not occur. Also, writing to the debug does not work. In the visual editor, detection zones are displayed in green, as expected.
If you select several regions in the visual editor, then the values of the sequence without a space are entered into the region of interest, that is, 0x0x10x10,9x9x19x19 instead of 0x0x10x10, 9x9x19x19, which leads to ignoring the entered data. In the visual editor, the entered zones disappear after saving.
In the visual editor, it is possible to enter the size of the zone with a zero value, which is incorrect. It is not visible. That is, 100x100x 0x10 is a size error.
Entering coordinates and size is not limited by the image resolution field. This leads to the possibility of going beyond the size
With a portrait aspect ratio (90 or 270 degrees), when triggering zones at the bottom of the screen, the red lines are not erased after the end of the rendering
The text was updated successfully, but these errors were encountered:
ssc338q (infinity6e family), imx415, 16 MB nor flash, 2.4.09.05-lite, openipc-ssc338q
If you select several regions in the visual editor, then motion detection and the call of the script motion.sh does not occur. Also, writing to the debug does not work. In the visual editor, detection zones are displayed in green, as expected.
If you select several regions in the visual editor, then the values of the sequence without a space are entered into the region of interest, that is,
0x0x10x10,9x9x19x19
instead of0x0x10x10, 9x9x19x19
, which leads to ignoring the entered data. In the visual editor, the entered zones disappear after saving.In the visual editor, it is possible to enter the size of the zone with a zero value, which is incorrect. It is not visible. That is,
100x100x 0x10
is a size error.Entering coordinates and size is not limited by the image resolution field. This leads to the possibility of going beyond the size
With a portrait aspect ratio (90 or 270 degrees), when triggering zones at the bottom of the screen, the red lines are not erased after the end of the rendering
The text was updated successfully, but these errors were encountered: