Skip to content
New issue

Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.

By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.

Already on GitHub? Sign in to your account

Default encoder mode #42

Open
marcelldls opened this issue Nov 9, 2023 · 0 comments
Open

Default encoder mode #42

marcelldls opened this issue Nov 9, 2023 · 0 comments

Comments

@marcelldls
Copy link

When switching from the Faraday firmware on the pandabrick, the motion controller was no longer able to read the ENDAT encoder (quad encoders were OK). The basic behaviour expected was to act as a pass through for the encoder signals. It was measured that a clock signal was no longer being transmitted (therefore impacting operation of the encoder). It is understood that this may be a mode switch issue (between monitor and control) which is set by a relay

Sign up for free to join this conversation on GitHub. Already have an account? Sign in to comment
Labels
None yet
Projects
None yet
Development

No branches or pull requests

1 participant