STOP after prime_blob to reach the set temperature

[AmshaSharam]

What happened

Printer: Vcore 3
I'm using the latest version,
(Distro: RatOS v2.1.0-RC 2 (bullseye)),
I noticed that it forces me to use the Start_print... macro, however, after running prime_blob the nozzle remains stopped until it reaches the set temperature, while it is stopped, depending on the time, the nozzle lets some filament come out, which then creates problems in the first layer. Is it possible to cancel this pause? How to stop using the Start_print macro, if possible?

What did you expect to happen

Cancel the wait temp target.
Able not use the start_print

How to reproduce

?!

Additional information

No response