🛈 This script can not be used on its own but requires the base installation. See main README for details.
This script is run from scheduler periodically, sending notification on health related events:
- voltage jumps up or down more than configured threshold
- power supply failed or recovered
- temperature is above or below threshold
Note that bad initial state will not trigger an event.
Only sensors available in hardware can be checked. See what your hardware supports:
/ system health print;
Just install the script and create a scheduler:
$ScriptInstallUpdate check-health;
/ system scheduler add interval=1m name=check-health on-event="/ system script run check-health;" start-time=startup;
The configuration goes to global-config-overlay, these are the parameters:
CheckHealthTemperature: an array specifying temperature thresholds for sensorsCheckHealthVoltagePercent: percentage value to trigger voltage jumps
Also notification settings are required for e-mail, matrix and/or telegram.