printer.cfg

[mcu]
canbus_uuid: db147f4b05ac

[mcu ebb]
canbus_uuid: dad2679b79f6

[controller_fan electronics_fan]
pin: PD15
stepper: stepper_x,stepper_y

[printer]
kinematics: corexy
max_velocity: 1360
max_accel: 22800
max_accel_to_decel: 7800
square_corner_velocity: 10.0
max_z_velocity: 15
max_z_accel: 300

[input_shaper]
shaper_freq_x: 81.4
shaper_type_x: zv
shaper_freq_y: 45.4
shaper_type_y: mzv

[include printer.d/pins.cfg]
[include printer.d/trinamic.cfg]
[include printer.d/steppers.cfg]
[include printer.d/extruder.cfg]
[include printer.d/bed.cfg]
[include printer.d/chamber.cfg]
[include printer.d/display.cfg]
[include printer.d/menu.cfg]
[include printer.d/lights.cfg]
[include printer.d/power.cfg]
[include printer.d/misc.cfg]
[include klicky/klicky-probe.cfg]
[include printer.d/macros-ui.cfg]
[include printer.d/macros-debug.cfg]
[include printer.d/macros.cfg]
[include printer.d/adxl345.cfg]

#*# <---------------------- SAVE_CONFIG ---------------------->
#*# DO NOT EDIT THIS BLOCK OR BELOW. The contents are auto-generated.
#*#
#*# [extruder]
#*# control = pid
#*# pid_kp = 26.323
#*# pid_ki = 2.700
#*# pid_kd = 64.163
#*#
#*# [heater_bed]
#*# control = pid
#*# pid_kp = 59.826
#*# pid_ki = 3.296
#*# pid_kd = 271.460
#*#
#*# [chamber_heater]
#*# control = pid
#*# pid_kp = 69.081
#*# pid_ki = 2.559
#*# pid_kd = 466.298
#*#
#*# [endstop_phase stepper_z]
#*# trigger_phase = 44/64
#*#
#*# [endstop_phase stepper_z1]
#*# trigger_phase = 46/64