-
Notifications
You must be signed in to change notification settings - Fork 494
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
NRF52840 UART Problem #732
Comments
could you provide the following info for analysis |
I found out, that the problem only occurs when the mobile phone and controller are paired/bonded. My devices were still bonded. |
@bromic1 thanks for the extra info, though I still need all the information 1-5 as mentioned in above post for reproducing. |
Describe the bug:
I cannot send data from the device to my mobile using UART.
Set up
To Reproduce
Expected behavior
Sometimes it already doesnt work without the reset. Sending from the App to Controller always works.
Strange is that when I comment out the blebas lines it works as exprected
When you leave Uart mode in the App and go back to Uart it also works even with blebas. But the red LED is blinking twice.
It seem that there is an interference with blebas.
The text was updated successfully, but these errors were encountered: