You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
if i clicked the up-left button on ugs, my machine is running left (two steppers are running). if i clicked left, the cnc is going up-left (only one stepper is running). the z axis is controlled by servo, while the x and y axis are controlled by a stepper motor
if i clicked the up-left button on ugs, my machine is running left (two steppers are running). if i clicked left, the cnc is going up-left (only one stepper is running). the z axis is controlled by servo, while the x and y axis are controlled by a stepper motor
$$
$0 = 10 (step pulse, usec)
$1 = 25 (step idle delay, msec)
$2 = 131 (step port invert mask:10000011)
$3 = 1 (dir port invert mask:00000001)
$4 = 0 (step enable invert, bool)
$5 = 0 (limit pins invert, bool)
$6 = 0 (probe pin invert, bool)
$10 = 3 (status report mask:00000011)
$11 = 0.010 (junction deviation, mm)
$12 = 0.002 (arc tolerance, mm)
$13 = 0 (report inches, bool)
$20 = 0 (soft limits, bool)
$21 = 0 (hard limits, bool)
$22 = 0 (homing cycle, bool)
$23 = 0 (homing dir invert mask:00000000)
$24 = 25.000 (homing feed, mm/min)
$25 = 500.000 (homing seek, mm/min)
$26 = 250 (homing debounce, msec)
$27 = 1.000 (homing pull-off, mm)
$100 = 125.000 (x, step/mm)
$101 = 120.000 (y, step/mm)
$102 = 250.000 (z, step/mm)
$110 = 125.000 (x max rate, mm/min)
$111 = 120.000 (y max rate, mm/min)
$112 = 500.000 (z max rate, mm/min)
$120 = 10.000 (x accel, mm/sec^2)
$121 = 10.000 (y accel, mm/sec^2)
$122 = 10.000 (z accel, mm/sec^2)
$130 = 200.000 (x max travel, mm)
$131 = 200.000 (y max travel, mm)
$132 = 200.000 (z max travel, mm)
ok
The text was updated successfully, but these errors were encountered: