-
Notifications
You must be signed in to change notification settings - Fork 14
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
si init OK / tx OK /ready OK / tx OK but then NOCTS follows #1
Comments
Please be sure that your chip has a revision "B1". The radio_config.h from repo + 26MHz XTAL must produce 432.400 MHz |
Hi Alexander, thanks for your reply. Caught by the flue it took me some time to react. Sorry Tonight I succesfully prepared my own radio_config.h for 144.3375 MHz . I completely forgot to change the GPIO settings and to use the "Direct TX" project setting. So it made sense that the unit did not start with TX. I have a chip revision C2 with 30 MHz Xtal and that works OK. Do you happen to have an RTTY (FSK) example laying around ? Thanks, |
Hi,
I assembled a Pro Mini and the SI4463 board together. The serial console gives the message as in the title but no CW is transmitted. I expect to see it on 432.400 MHz ( + or - some kHz) but on the SDR with 1 MHz bandwidth no signal shows up.
I did read the part about the radio_config.h but I assume that if for testing I am fine with the frequency and power I can use the radio_config.h which is in the src\si4463\radio folder ?
Any help on this ?
Thanks,
Ben - PE2BZ from the Netherlands
The text was updated successfully, but these errors were encountered: