-
Notifications
You must be signed in to change notification settings - Fork 4.8k
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
Sonoff POW R2 duplicate mqtt message #2891
Comments
For help please post status 0 |
Hi Jason, can you explain me what is "Status 0" ? |
In web front end hit button "Console" |
|
From status 0 I suggest to disable serial logging as the interface is used by the POW energy monitoring hardware: With low loads any powerdelta might report a message so I would disable powerdelta for now and see what happens: As teleperiod is set too 300 (seconds) I cannot explain why you receive messages every 20 seconds... |
With |
Enable
|
Here it is:
|
Looking at the CF count (byte 21and 22 being E2, E3, E4) there seems to be a very low power load connected. This is also represented in many unmeasurable power loads indicated by byte 20 which should say 71 when power, voltage and current could be measured. I see many 61 = invalid power meaning to power load is too low to measure. Suggestions:
|
Ok you're right... the load was minimal (5w)... I've attached a 60w light bulb and now it work! |
Hi all,
I've flashed the Sonoff POW R2 with Tasmota (self compiled with platformio).
In the main page I see no power value
In the console I've found that there's always a duplicate MQTT message for the current/power value:
Anoyone else having the same problem? solution?
Thanks
Andrea
The text was updated successfully, but these errors were encountered: