Sovol SV06+ - does not use the default mesh ?

[Manfredo1952]

Just realise that (or it seems so at least) that the printer is not using the info/data of the default mesh. When I print a layer of say 0.24 mm, there is one area where the filament gets cut open... and I don't see the zsteppers movisng whilst printing ? What can I do to test/verify ?

regards

[bassamanator]

If kamp is disabled, the default mesh is loaded.

If you did not have a mesh named default, print_start would crash.

Therefore, if you're not crashing, and kamp is not enabled based on your observations (ignore the code), the default mesh is in fact being loaded.

I sometimes see marks on the top surfaces of my prints where the nozzle didn't quite lift high enough when travelling to another position, I think that's what you're experiencing. How bad are the cuts? Can you print issue free or is this affecting your ability to get a clean print?

[Manfredo1952]

Thanks for the comments. I have done a few more tests. After 2-3 reboots I can now see the zsteppers working and I have slowed down printing the first layer to 50 mm/s as well have increased flow rate for the first layer to 1,1 (1 otherwise), Looks a lot better now- Thought I could print first layer with 125 as well, may be not a good idea.. Kamps works very well. Thanks !