BL TOUCH not working on marlin

[slowmosquito]

Hello

i have a bigtreetech e3 rrf installed on ender3

it works ok , also wifi works ok and all is very well

i installed a bltouch and enabled on firmware marlin the auto bed level.

When i give auto level command the pronter starts procedure but stops at first point

Attached a txt file with debug, i see the error no trigger

i definied this #define Z_MIN_PROBE_PIN 32 // Pin 32 is the RAMPS default

The bltouch probe is connected to Z PROBE 5 pin

i attach also configuration.h (on txt format) file

any suggestion aprecied

thanks
debug.txt
Configurationh.txt