You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I am in the process of testing a new machine
After changing the information in the configuration file i performed the following operation
homed the x axis
then i ran a short gcode that moved 600mm and then returned 600mm
The x axis move past the 600mm mark and of course hit a hard endstop. and stalled the motors.
I then reset the board homed the x axis again this time i hit the reset button and then ran the gcode. this time the movements were as planned 600mm + direction and 600mm - direction
there seems to be a bit of a bug in the firmware.
The text was updated successfully, but these errors were encountered:
I am in the process of testing a new machine
After changing the information in the configuration file i performed the following operation
homed the x axis
then i ran a short gcode that moved 600mm and then returned 600mm
The x axis move past the 600mm mark and of course hit a hard endstop. and stalled the motors.
I then reset the board homed the x axis again this time i hit the reset button and then ran the gcode. this time the movements were as planned 600mm + direction and 600mm - direction
there seems to be a bit of a bug in the firmware.
The text was updated successfully, but these errors were encountered: