k10133.rno

.AP.SP 2
.PS 60,70
 Kermit-10 now has a lot of patches put into it.  The first set of
patches is based on those submitted by PIMA.  The subsequent patches are
added in order to make Kermit-10 similar to Kermit-32.  The last patch is
to change all the search file names to K10??? as opposed to KER???.
.B 2
.HL 1;PATCH [127]
 Based on the patches we received from PIMA the following changes have
been added to KERMIT and KERUNV.
.B.LS
.LE;Fix IFN stopcode if syntax error in KERMIT.INI.
.LE;Add help text for connect mode ESCape commands.
Q (Quit) and R (Resume) logging
.LE;Add SET XON-XOFF-PROCESSING to determine how Xon/Xoff should be handled
during connect.
.LE;Add a new File Byte Size of 36-Bits for 10/20 transfers
.ELS.B
 These changes are in Modules KERMIT and KERUNV
.b
.HL 1;PATCH [130] _& [3_.1_.045]
 When attempting to do multiple file sends from Kermit-10, the prompt
indicating subsequent sends is screwed up.  It sends:  the sent file name,
followed by, "as ", "Sending: ", and then, the original file name.  This is
due to the timing of when NEXT__FILE prints the "Sending: " prompt.
The fix is to take the subsequent file sending prompt out of KERMSG
and put it into KERMIT.  This fixes the problem, but it also requires
a similar patch to be put into KERMIT-32 and PROKERMIT.
.B
 Changes were to Modules KERMIT and KERMSG.
.B
.HL 1;PATCH [131], [132], _& [133]
 Make KERMIT-10 look similar to KERMIT-32.  Alow KERMIT to set the IBM
handshaking character, incase the IBM character is something other
than _^Q.  Fix the IBM macro defined to set up the three parameters
required for IBM transfers, this means to add in the setting of the
handshake character.  The kludge use of IBM-MODE is no longer needed,
remove it.
.B
 The changes are in Module KERMIT
.B
.HL 1;PATCH [134]
 Since the distribution files for KERMIT-10 are changed to K10???.???,
lets make the source file names that in the first place.  This
requires that all search file names must be changed to K10???.  The
prologue in K10UNV should remain as KERMIT or else you won't be able
to find the help file for KERMIT.  Also there is a new help file
which contains the SET HANDSHAKE and SET XON-XOFF-PROCESSING help.
The help file also modifies the the SET IBM-MODE command to SET IBM
which initiates the IBM macro.
.B
 These changes were done to ALL Modules.