Skip to content

Latest commit

 

History

History
98 lines (64 loc) · 3.37 KB

README.md

File metadata and controls

98 lines (64 loc) · 3.37 KB

Raspberry Pi Zero as an IoT Device

Raspberry Pi Zero

A Raspberry Pi Zero was chosen as the compute element of the project as it had a number of desirable features:

  • Low cost
  • Low power consumption (Essential in a solar powered project)
  • Excellent software support
  • Wide range of sensors available
  • Small physical size
  • Built-in WiFi

The model chosen was the Raspberry Pi Zero W (No soldered header, WiFi onboard). Only the required pins for the I2C interface and the onbaord reset where added.

As a precaution, a copper heatsink was also added to the processor. While unlikely to overheat, the environmental temperature may get high due to possible solar heating effects.

Security

...or how not to get owned by a the script kiddies

A run down of how to secure an RPi device can be found here. Documentation

In summary:

  • Update the software
  • Use SSH
  • Create a new user and delete the pi user
  • Install and configure a firewall

UFW Firewalll Rule

A simple rule to limit ssh connections from one network area.

sudo ufw limit from 192.168.0.0/24 to any port 22 proto tcp

Sensor Package

The sensor package chosen was the BME280 from Bosch. This device is capable of supplying accurate temperature, pressure and humidity data over the I2C bus. The device is very low cost and is readily available from various sources, including eBay. The only difference I have found with various implementations is the I2C bus address. This can be easily found by use of the sudo i2cdetect -y 1 which should give a display such as:

     0  1  2  3  4  5  6  7  8  9  a  b  c  d  e  f
00:          -- -- -- -- -- -- -- -- -- -- -- -- -- 
10: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 
20: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 
30: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 
40: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 
50: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 
60: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 
70: -- -- -- -- -- -- 76 --

Note: If the command is not present, install using sudo apt-get install i2c-tools

The required connections for the sensor module to I2C are:

Module PCB Usage GPIO Header
VCC 3.3V P1-01
GND Ground P1-06
SCL I2C SCL P1-05
SDA I2C SDA P1-03

Power Supply and Power Management

The aim of the power supply is to generate a stable 5V supply with sufficient power to enable operation of the Raspberry Pi. Power is derived from either a solar panel or a LiPo battery when sunlight is not available. The chosen system comprises the following off the shelf components from Adafruit

  • 6V solar panel - must be sufficient to generate power during winter
  • LiPo charge controller - able to switch between solar and battery sources. Excess solar used to recharge the battery
  • DC / DC converter with 5V output
  • LiPo battery

Full details here

Software

The software was required to perform three tasks

  • Read sensor data
  • Send data to AWS when WiFi is available
  • Store data for later transmission when WiFi is not available

Full details here

Prototype Hardware