- Arduino sketch that works meh for windows and menu keys
- they occasionally miss the release so ill have to make the code gooder later
- used kailh choc brown switches cause theyre low profile to sit on the plastic
- first routed wires from around the backplate thingy so they come up out the top to the left of each missing key area
- measured the distance needed for the keyswitches and cut the wire to length
- soldered the wires to the switches
- pulled the wires through on the back, staying out of the way of supports
- met the wires together over the hole thingy that looks like its for a speaker or something
- cut the wires to lentch to fit in the arduino
- soldered the wires into the correct pins
- here I used pins 2 and 3 becuase they are interrupt pins and then connected the other pins to gnd
- cut a usb cable in half beyond the distance I needed to fit it in the keyboard
- my usb port was facing towards the back so I looped it 360° to go through the slots
- solder the usb wires back together and jankily electrical tape it cause you didn't buy heat shrink
- the 3-D model here supports the keyswitches so they don't wobble since they were designed to be inserted in something
- at this point I just hot glue the switches on top after making sure the wires don't interfere with the keys next to it
- I need to figure out painting or somethinging logos on the keyswitches
- definitely want a Tux the Linux penguin one
- a windows 2.0 logo would be interesting cuase the era is roughly right, it was able to run on the ps/2
- I guess unicomp made the model M with a windows key and it was the old like 95 looking one so maybe that if I print it or something
- maybe the ibm p2/s logo since this was used for the ibm ps/2
- os/2 I guess is the os it ran