Torque sensor calibration issues

[ChrisAxt]

Hi, I hope someone can help me with this.

I have obtained the min and max values for the torque sensor by following the instructions in the display manual (VLCD5). The values I got were 7.4 and 14.7 for min and max respectively. I assume that because of the limited space on the display (Only allowing for 3 numbers) that these values translate to 74 and 147.

After entering them in the config (Pedal torque ADC offset (no weight) and Pedal torque ADC max (max weight)) and flashing the motor, I get a E02 error on power up. I have tried enabling/disabling torque sensor adv as well as the estimated flag for Pedal torque ADC step, but the error still persists.

Based on the default values for the min and max, the values I get seem a bit low, but I don't know enough about these parameters to be able to pinpoint the issue.

Any help would be appreciated!