Skip to content

Latest commit

 

History

History
41 lines (24 loc) · 2.45 KB

README.md

File metadata and controls

41 lines (24 loc) · 2.45 KB

ESPAsyncE131 - Asynchronous E.131 (sACN) library for Arduino ESP8266 and ESP32

Build Status

This library is to simplify the validation and handling of E1.31 sACN (DMX over Ethernet) traffic on Arduino ESP8266 and ESP32 based platforms. It supports both Unicast and Multicast configurations, exposing the full E1.31 packet to the user. If you require support for traditional Arduino devices or polling modes, please refer to the E131 library from which this project was derived from.

Requirements

Development is always done against the latest git pulls for the ESP8266 and ESP32 cores. If you are experiencing issues with your current Arduino core, consider updating it.

ESP8266 Platforms

ESP32 Platforms

API / Usage

Notes

  • All incoming E1.31 packets are put into a ring buffer once validated. You access incoming packets by checking the ring buffer and pulling packets as needed.
  • WiFi connection attempts will timeout after 10 seconds if a successful connection has not been established. WIFI_CONNECT_TIMEOUT can be changed in ESPAsyncE131.h.

Constructor

  • ESPAsyncE131(uint8_t buffers = 1): Creates a new ESPAsyncE131 instance and allocates a ring buffer with X buffer slots. You'll want at least 1 buffer for each Universe that may reach your device.

Member Functions and Exposed Data Structures

  • bool begin(e131_listen_t type, uint16_t universe = 1): This should be called from within setup() or whenever you need to re-configure your E1.31 listener. Valid types are E131_UNICAST and E131_MULTICAST. universe is optional and only used for Multicast configuration. Returns true if successful.
  • bool isEmpty(): Returns if the internal ring buffer is empty
  • void *pull(e131_packet_t *packet): Pulls oldest packet from the ring buffer and copies it to packet
  • e131_stats_t stats: E1.31 Statistics

Resources