Filament Runout does not trigger

[Ivanuke]

The runout sensor does not get triggered. The tangle sensor works as expected and resumes as normal. Is the runout sensor configured with the Open Q1 software?

[damanbaird]

Do you have this:

pause_on_runout:True
runout_gcode:
RESET_FILAMENT_WIDTH_SENSOR
M118 Filament run out

[Ivanuke]

Yes I have that in the q1.cfg file. Under Tune I only show the tangle sensor as active, not sure if a runout sensor should be there as well

[frap129]

Sorry for the delay. I also had this issue once, I believe this is related to QIDI_Q1_Pro/issues/65. I can try to test using the values from that issue, but the values in open q1 have also been calibrated separately. Ultimately, the sensor itself is garbage, and there may not be much that can be done to solve it.