Insteon: Add Initial Support for Linking i2cs Devices in MH #213
Conversation
This file contains bidirectional Unicode text that may be interpreted or compiled differently than what appears below. To review, open the file in an editor that reveals hidden Unicode characters.
Learn more about bidirectional Unicode characters
No longer do you have to manually link i2cs devices. Added: enter_linking_mode() Places the object into linking mode as if you had held down the set button on the device. To create a link wherein the PLM is the controller, first run the PLM voice command "initiate link as controller". Then run this command. Finally, run the voice command "scan link table" on this device. This will eventually be merged into a simpler one-step method, however that will require some additional coding.
krkeegan
added a commit
that referenced
this pull request
Jun 8, 2013
Insteon: Add Initial Support for Linking i2cs Devices in MH
Merged
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
Add this suggestion to a batch that can be applied as a single commit.
This suggestion is invalid because no changes were made to the code.
Suggestions cannot be applied while the pull request is closed.
Suggestions cannot be applied while viewing a subset of changes.
Only one suggestion per line can be applied in a batch.
Add this suggestion to a batch that can be applied as a single commit.
Applying suggestions on deleted lines is not supported.
You must change the existing code in this line in order to create a valid suggestion.
Outdated suggestions cannot be applied.
This suggestion has been applied or marked resolved.
Suggestions cannot be applied from pending reviews.
Suggestions cannot be applied on multi-line comments.
Suggestions cannot be applied while the pull request is queued to merge.
Suggestion cannot be applied right now. Please check back later.
No longer do you have to manually link i2cs devices.
Added: enter_linking_mode()
Places the object into linking mode as if you had held down the set button on the device. To create a link wherein the PLM is the controller, first run the PLM voice command "initiate link as controller". Then run this command. Finally, run the voice command "scan link table" on this device.
This will eventually be merged into a simpler one-step method, however that will require some additional coding.