Noxe V1-INAV/FLYWOOF411 2.6.0

[Finnigan1971]

Noxe V1, # INAV/FLYWOOF411 2.6.0 Dec 4 2020 / 11:03:18 (cada68e)

GCC-9.2.1 20191025 (release) [ARM/arm-9-branch revision 277599]

With Dshot (all three) motor 3 don't spin (even in the configurator), with Oneshot (both versions) the four motors spin weird.

dump inav 10-12-2020.txt

[vaicekas]

I want to confirm that the motor No. 3 is operating abnormally.
In the configurator, all four motors spinning only when the master slider is moved.
With slider motor no. 3 - the motor does spinning, but ESC beeps like a restarting.
When the quadcopter armed on the ground all engines spinning, but switching to hold altitude mode- shuts down the third engine.

[rickgode]

I "think" have this same issue. On a stock flywoo explorer with the flywoof411 board only motor 1 spins. When I move the master slider only motor 1 spins the other 3 do nothing. I've tried dshot 150,300/multishot/oneshot. I only get anything to work with dshot, but again, only one motor spins.

I have verified that all 4 motors work as intended with the betaflight version it came with. The master slider spins all 4 and each individual slider spins the corresponding motor.

Also I don't think the LEDs on the board are working correctly.

Ricky

[stronnag]

Following some discussion on RCG, @rickgode was able to get information from the vendor as to the V2 changes. They seem to have gone all "Omnibus" on us, with a V2 that has only superficial resemblance to V1.

Attached (Zip file)
inav_FLYWOOF411_V2.hex.zip
2.6.0 and 2.7.0 V2 hex files, bench tested by @rickgode as working.

PR to follow RSN.

[stronnag]

Fixed by #6495

[s2kaka]

can i use this FC for a Wing?