The captured image rotates.

[PeterLustig33]

I have set the system correctly. All measuring points are configured cleanly. (Picture1) The acquisition works perfectly. After some time, the Esfassung no longer works. If I then look on the Main Page the picture is rotated. (Picture2). Sometimes only a few degrees, sometimes 180 degrees (Image3) I can reproduce the same after each restart.
The reference image is always correct.

Bild1

Bild2

Bild3

[haverland]

Looks like you use analog ROI on digits? Bild1

sometines it is not Easy to setup alignement. Try other alignement points

[PeterLustig33]

I have tried all ROI versions. When the image is displayed straight, the digits are also recognized well. The problem is that the newly captured image often rotates. (Image2/3) Then nothing is recognized correctly.
It just happened again. The system took 4 pictures and detected the values correctly. The 5th image was then rotated about 10° to the right. And the evaluation did not work anymore

.

[haverland]

Your alignement is on a digit. Use for alignement something that Not changing and have a good contrast

[JensHoRi]

Would assist that. Because my counter also has less marking points, I made good experience with the , between black and red area

[pos-ei-don]

Why not simply Stick something with good contrast somewhere onthe glass?

[JensHoRi]

It’s a solution too. In my case (while using mirror case) the area is really small and it just worked with those areas too :)

but please close issue, because it’s a configuration failure (should discussed in Q&A) and not a software issue

[PeterLustig33]

Thank you for the tips.
Yes it was a configuration error