Skip to content

Latest commit

 

History

History
30 lines (20 loc) · 1.35 KB

README.md

File metadata and controls

30 lines (20 loc) · 1.35 KB
Raw

Arduino MIDI Controller

This project allows you to build a flexible MIDI controller for switching programs and banks.

Features

  • Program Change: Press any configured button to switch programs within the current bank.
  • Bank Navigation: Press buttons 1 and 2 simultaneously for "bank up", or buttons 2 and 3 for "bank down".
  • Adaptable Button Configuration: You need >=3 buttons, according to the number of buttons connected, the programm will figure out the amount of banks necessary for a full coverage across the 128 MIDI channels
  • LCD Feedback: Provides visual feedback on the current bank and program selection via an LCD display.

Hardware Requirements

  • Arduino Uno or compatible board
  • Push buttons (minimum 3 required for basic functionality)
  • LiquidCrystal LCD display (16x2 or compatible)
  • Jumper wires and breadboard for connections
  • Optional: resistors for buttons if not using INPUT_PULLUP mode

Software Requirements

  • Arduino IDE for uploading the code to the Arduino board

Setup and Configuration

  1. Wiring: Connect the buttons and LCD display to your Arduino, adapt the pin configuration to match your setup at the top of the sketch.
  2. Upload: Use the Arduino IDE to compile and upload the sketch to your Arduino board.

License

This project is open source and available under the MIT License.