This repository was archived by the owner on Dec 9, 2020. It is now read-only.
Individual LED Control
In this panel you can control an individual LED.
The setup in this panel, is the same as was put in the Configure Setup section. However the hardware ID's are now shown as buttons.
Down in the buttom, are located trackbars to change the color that you want to send. After you have selected your desired color, you simply press the buttons in the series. This will make the button the given color, as well as sending that color over to the actural LED. You can also color an entire strip, by checking the checkbox down in the button, then you can again press on an LED, and the program will instead send that color to that entire series strip.