-
Notifications
You must be signed in to change notification settings - Fork 18
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
Nano V2 on Delta, is it possible? #8
Comments
I think you need check your manchine limit NC or NO status |
I have successfully mounted this board on a delta last weekend. I also use max endstops and had no problems with it. On the board, the X-STOP and Y-Stop ports are max-endstops, even if it's not written there. Use Z+ Port for the Z endstop and Z- for a probe. |
@ikkez |
@mks-viva my current configuration ikkez/Mks-Robin-Nano-Marlin2.0-Firmware@c139ef5 |
Hello everyone, I bought this board for the good results that V1.2 has given me.
The problem is that I have it mounted on a Delta and I have no way to make it work.
One of the problems is that delta use max endstop, and this board does not have them, but it is indicated that it is functional with Delta.
The movements were performed well, when moving the z axis all the motors work to join or lower the car.
But when I do a homing, it goes crazy and the engines give a terrible blow.
Does anyone have this plate mounted on a delta?
Thank you very much in advance.
The text was updated successfully, but these errors were encountered: