[Bug]: boot loop after fresh install heltec wireless tracker 1.1

[megabyte2010]

Category

Hardware Compatibility, Other

Hardware

Heltec Wireless Tracker

Firmware Version

2.5.6

Description

I've got a boot loop, flashing the latest firmware 2.5.6 with the online flasher, even with erasing memory. 2.5.5 works ok.

Relevant log output

No response

[caveman99]

can you add a serial debug log?

[thebentern]

Also make sure you have the correct version of the target firmware. There is a v1.0 and v1.1 of the Heltec Wireless Tracker

[fifieldt]

I've building a heltec-wireless-tracker v1.1 from master much of today and it was OK...

@megabyte2010 , in case you're unfamilar with serial logs, you may obtain these by clicking the Open Serial Monitor button at the bottom of https://flasher.meshtastic.org/

[bjpetit]

I'm also seeing a boot failure/loop on a T-Beam after flashing 2.5.6. I did multiple erase and install attempts with the same results. Going back to 2.5.5 works fine.
T-Beam-2.5.6-failure.txt

[thebentern]

Looks like an existing bug report. Closing this as duplicate and tracking in
#5017