Skip to content

Latest commit

 

History

History
26 lines (19 loc) · 1.33 KB

EMS_SmartPi.md

File metadata and controls

26 lines (19 loc) · 1.33 KB
Raw

SmartPi EMS Module

This module allows querying of SmartPi power sensors.

Note: Only Generation values are supported by this module. The power measured by the sensor will be evaluated as Generation if the value is Negative, or Consumption if the value is Positive and showConsumption is enabled, otherwise zero.. As a result, only a Generation or Consumption value should be shown at any time, but never both.

Introduction

Parameter Value
enabled required Boolean value, true or false. Determines whether we will poll the SmartPi Device
serverIP required The IP Address of the SmartPi Device
serverPort required The Port on which the SmartPi API is reachable
showConsumption optional Determines whether we should show a negative Generation figure as zero (False, default), or as a positive Consumption figure (True). Note that this should not be enabled if you're using subtractChargerLoad in your config.json.

JSON Configuration Example

The following configuration should be placed under the "sources" section of the config.json file in your installation, and will enable SmartPi EMS polling.

"SmartPi": {
  "enabled": true,
  "serverIP": "192.168.1.2",
  "serverPort": "1080"
}