You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
{{ message }}
This repository has been archived by the owner on Sep 30, 2021. It is now read-only.
It works without any problems. Now when I change card for WPEA and try to create hotspot using create_ap (modifying config parameter WIFI_IFACE first) I get.
lspci -v
00:00.0 PCI bridge: Synopsys, Inc. Device abcd (rev 01) (prog-if 00 [Normal decode])
Flags: bus master, fast devsel, latency 0, IRQ 311
Memory at 01000000 (32-bit, non-prefetchable) [size=1M]
Bus: primary=00, secondary=01, subordinate=01, sec-latency=0
Memory behind bridge: 01100000-011fffff
Prefetchable memory behind bridge: 01200000-012fffff
[virtual] Expansion ROM at 01300000 [disabled] [size=64K]
Capabilities: <access denied>
Kernel driver in use: pcieport
01:00.0 Network controller: Qualcomm Atheros AR93xx Wireless Network Adapter (rev 01)
Subsystem: Qualcomm Atheros AR93xx Wireless Network Adapter
Flags: bus master, fast devsel, latency 0, IRQ 343
Memory at 01100000 (64-bit, non-prefetchable) [size=128K]
[virtual] Expansion ROM at 01200000 [disabled] [size=64K]
Capabilities: <access denied>
Kernel driver in use: ath9k
Kernel modules: ath9k
sudo /opt/scripts/create_ap --config /etc/opt/config/create_ap.conf
Config dir: /tmp/create_ap.wlp1s0.conf.W9XzBnhu
PID: 7302
Network Manager found, set wlp1s0 as unmanaged device... DONE
No Internet sharing
hostapd command-line interface: hostapd_cli -p /tmp/create_ap.wlp1s0.conf.W9XzBnhu/hostapd_ctrl
WARN: Low entropy detected. We recommend you to install `haveged'
Configuration file: /tmp/create_ap.wlp1s0.conf.W9XzBnhu/hostapd.conf
wlp1s0: interface state UNINITIALIZED->COUNTRY_UPDATE
Using interface wlp1s0 with hwaddr 00:0e:8e:88:8a:5d and ssid "AirRate_21_005"
random: Only 16/20 bytes of strong random data available from /dev/random
random: Not enough entropy pool available for secure operations
WPA: Not enough entropy in random pool for secure operations - update keys later when the first station connects
wlp1s0: interface state COUNTRY_UPDATE->ENABLED
wlp1s0: AP-ENABLED
Low entropy warning also occurs when I run this script on EMMY card so I do not think it is causing problems with hotspot.
Journalctl logs:
Mar 26 13:57:28 nitrogen sudo[6593]: ubuntu : TTY=tty1 ; PWD=/home/ubuntu ; USER=root ; COMMAND=/opt/fev/fach/FachWebServer/scripts/create_ap --config /etc/opt/fach/config/create_ap.conf
Mar 26 13:57:28 nitrogen sudo[6593]: pam_unix(sudo:session): session opened for user root by ubuntu(uid=0)
Mar 26 13:57:29 nitrogen NetworkManager[2235]: <info> [1616763449.0499] reload configuration (signal Hangup)...
Mar 26 13:57:29 nitrogen NetworkManager[2235]: <info> [1616763449.0518] config: update /etc/NetworkManager/NetworkManager.conf (etc: default-wifi-powersave-on.conf) (SIGHUP,values,values-user)
Mar 26 13:57:29 nitrogen NetworkManager[2235]: <info> [1616763449.0576] get unmanaged devices count: 1
Mar 26 13:57:29 nitrogen NetworkManager[2235]: <info> [1616763449.0578] device (wlp1s0): state change: disconnected -> unmanaged (reason 'unmanaged') [30 10 3]
Mar 26 13:57:29 nitrogen wpa_supplicant[2075]: nl80211: deinit ifname=wlp1s0 disabled_11b_rates=0
Mar 26 13:57:32 nitrogen kernel: IPv6: ADDRCONF(NETDEV_UP): wlp1s0: link is not ready
Mar 26 13:57:32 nitrogen dnsmasq[6779]: started, version 2.75 DNS disabled
Mar 26 13:57:32 nitrogen dnsmasq[6779]: compile time options: IPv6 GNU-getopt DBus i18n IDN DHCP DHCPv6 no-Lua TFTP conntrack ipset auth DNSSEC loop-detect inotify
Mar 26 13:57:32 nitrogen dnsmasq-dhcp[6779]: DHCP, IP range 192.168.10.1 -- 192.168.10.254, lease time 1d
Mar 26 13:57:33 nitrogen kernel: IPv6: ADDRCONF(NETDEV_CHANGE): wlp1s0: link becomes ready
Mar 26 13:58:19 nitrogen NetworkManager[2235]: <info> [1616763499.1928] reload configuration (signal Hangup)...
Mar 26 13:58:19 nitrogen NetworkManager[2235]: <info> [1616763499.1947] config: update /etc/NetworkManager/NetworkManager.conf (etc: default-wifi-powersave-on.conf) (SIGHUP,values,values-user)
Mar 26 13:58:19 nitrogen NetworkManager[2235]: <info> [1616763499.2008] get unmanaged devices count: 1
Mar 26 13:58:19 nitrogen NetworkManager[2235]: <info> [1616763499.2010] device (wlp1s0): state change: unmanaged -> unavailable (reason 'managed') [10 20 2]
Mar 26 13:58:19 nitrogen kernel: IPv6: ADDRCONF(NETDEV_UP): wlp1s0: link is not ready
Mar 26 13:58:19 nitrogen kernel: IPv6: ADDRCONF(NETDEV_UP): wlp1s0: link is not ready
Mar 26 13:58:19 nitrogen kernel: IPv6: ADDRCONF(NETDEV_UP): wlp1s0: link is not ready
Mar 26 13:58:19 nitrogen sudo[6593]: pam_unix(sudo:session): session closed for user root
Mar 26 13:58:19 nitrogen wpa_supplicant[2075]: dbus: wpa_dbus_get_object_properties: failed to get object properties: (none) none
Mar 26 13:58:19 nitrogen wpa_supplicant[2075]: dbus: Failed to construct signal
Mar 26 13:58:19 nitrogen NetworkManager[2235]: <info> [1616763499.3354] device (wlp1s0): supplicant interface state: starting -> ready
Mar 26 13:58:19 nitrogen NetworkManager[2235]: <info> [1616763499.3371] device (wlp1s0): state change: unavailable -> disconnected (reason 'supplicant-available') [20 30 42]
Mar 26 13:58:19 nitrogen kernel: IPv6: ADDRCONF(NETDEV_UP): wlp1s0: link is not ready
Mar 26 13:58:22 nitrogen NetworkManager[2235]: <info> [1616763502.3468] device (wlp1s0): supplicant interface state: ready -> inactive
ubuntu@nitrogen:~$ ifconfig
eth0 Link encap:Ethernet HWaddr 00:19:b8:03:85:35
inet addr:192.168.8.10 Bcast:192.168.8.255 Mask:255.255.255.0
inet6 addr: fe80::219:b8ff:fe03:8535/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:1001 errors:0 dropped:0 overruns:0 frame:0
TX packets:596 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:97071 (97.0 KB) TX bytes:78277 (78.2 KB)
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:65536 Metric:1
RX packets:1181693 errors:0 dropped:0 overruns:0 frame:0
TX packets:1181693 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:364159273 (364.1 MB) TX bytes:364159273 (364.1 MB)
wlp1s0 Link encap:Ethernet HWaddr 00:0e:8e:88:8a:5d
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:4081 errors:0 dropped:0 overruns:0 frame:0
TX packets:1096 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:178581 (178.5 KB) TX bytes:151807 (151.8 KB)
But wifi network cannot be found (it is also not a hidden network)
When I try to connect to other Wi-Fi, I can only connect to ones that are not encrypted. When trying to connect to encrypted ones I get:
sudo nmcli device wifi connect mynetwork password mypassword
Error: Connection activation failed: (7) Secrets were required, but not provided.
I also tried to set hotspot using nmcli/nmtui and hostapd commends, with similar results.
For me the most important thing is to use the device as a hotspot.
The text was updated successfully, but these errors were encountered:
Sign up for freeto subscribe to this conversation on GitHub.
Already have an account?
Sign in.
Hi,
Recently I decided to switch my WIFI card from EMMY-W163 (datasheet: https://www.u-blox.com/sites/default/files/EMMY-W1_DataSheet_%28UBX-15011785%29.pdf) to WPEA-121N (https://www.sparklan.com/product/wpea-121n-ar9382-2t2r-wifi-module/). I am using a custom computer with Nitrogen6 SOM V2 (https://boundarydevices.com/product/nitrogen6-som-v2/). I use ubuntu 16.04.1LTS, kernel 4.1.15.
One of tasks I preform on this computer is to create a hotspot.
When using EMMY card, I can create hotspot using create_ap script with config:
It works without any problems. Now when I change card for WPEA and try to create hotspot using create_ap (modifying config parameter WIFI_IFACE first) I get.
I checked that WPEA card supports AP mode:
Running create_ap on computer with WPEA card:
Low entropy warning also occurs when I run this script on EMMY card so I do not think it is causing problems with hotspot.
Journalctl logs:
But wifi network cannot be found (it is also not a hidden network)
When I try to connect to other Wi-Fi, I can only connect to ones that are not encrypted. When trying to connect to encrypted ones I get:
I also tried to set hotspot using nmcli/nmtui and hostapd commends, with similar results.
For me the most important thing is to use the device as a hotspot.
The text was updated successfully, but these errors were encountered: