Skip to content
New issue

Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.

By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.

Already on GitHub? Sign in to your account

Perform Auto Z at KAMP Center #137

Open
Dylan144GT opened this issue Mar 11, 2024 · 1 comment
Open

Perform Auto Z at KAMP Center #137

Dylan144GT opened this issue Mar 11, 2024 · 1 comment

Comments

@Dylan144GT
Copy link

Hi,

Is it possible to add a feature where the auto z is performed in the center of the KAMP zone rather than in the middle of the bed. This is because it is good practice to print in different areas of the bed to ensure even wear, but the variance of the bed may be different in different KAMP zones.

Personally I find I need to adjust the z-offset whenever I don't print in the middle of the bed. One can argue that I don't have a flat bed, but I don't think that I am the only one in this position, especially on the more budget printers.

Thanks,

Dylan

@TitusLabs
Copy link
Member

Sorry, I don't use KAMP. But you can use the BED_POSITION parameter of the Z_CALIBRATION command. Would that be enough?

Sign up for free to join this conversation on GitHub. Already have an account? Sign in to comment
Labels
None yet
Projects
None yet
Development

No branches or pull requests

2 participants