Feature Request - Flow compensation for half-empty nozzle after low flow-rate for supports. #3767
digiTALker
started this conversation in
General
Replies: 0 comments
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
-
Hello! Im using support flow-rate below 100%, usually about 85%.
Nozzle diameter 1.2mm
With low density supports nozzle become partially empty. And when start print certain model spend time to fill nozzle.
Im asking to tune compensation filament volume (unretract) after low-flow contours or after supports.
Cheers.
Beta Was this translation helpful? Give feedback.
All reactions