You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
After upgrading to 2.1.2-ender-3-s1-F4-s1pro_abl my Ender 3 S1 Pro stops printing from OctoPrint often if I try to adjust either temperature, fan speed, or z offset. I am not sure if this is an OctoPrint issue or a firmware issue, but it didn't happen with the factory firmware. This is very frustration because the major reason I upgraded was to improve the compatibility of my Ender 3 S1 Pro with OctoPrint.
reacted with thumbs up emoji reacted with thumbs down emoji reacted with laugh emoji reacted with hooray emoji reacted with confused emoji reacted with heart emoji reacted with rocket emoji reacted with eyes emoji
-
After upgrading to 2.1.2-ender-3-s1-F4-s1pro_abl my Ender 3 S1 Pro stops printing from OctoPrint often if I try to adjust either temperature, fan speed, or z offset. I am not sure if this is an OctoPrint issue or a firmware issue, but it didn't happen with the factory firmware. This is very frustration because the major reason I upgraded was to improve the compatibility of my Ender 3 S1 Pro with OctoPrint.
Any advice would be appreciated,
Larry
Beta Was this translation helpful? Give feedback.
All reactions