Unable to access NAS using Tailscale IP

[petertellgren]

Hi,
Installed this package (v. 1.36.1. x86_64) yesterday on my TS-453A running QTS 5.0.1.2277.

Though everything seems to have gone fine and the app and Tailscale portal is reporting a solid connection and I've been given an IP I'm unable to access the nas using the IP either via browser or SSH..
I'm still able to access the nas from within my local network using the 192.168.x.x:8080 in broswer.

I'm sure I've missed some setting or step but I'm unable to find anything obvious.
Are there additional steps I need to take? Services I should switch on or off?

In lieu of a forum or other means of asking I opened this issue, not sure it's the best place.

[CHN008]

Maybe you need to check it: Use the"172.xx.xx.x::8080" to Access your NAS.

Of course, your local computer or mobile phone and other devices should also run Tailscale and be in the same virtual LAN as the NAS

[DentonGentry]

One problem in 1.36.1 is that the Tailscale login UI did not start up properly after the QNAP device rebooted. This is fixed in 1.40.0.

You should be able to reach the QNAP UI on its Tailscale IP address: http://100.x.y.z:8080/cgi-bin/
The LAN IP address also still works even with Tailscale running: http://192.168.x.x:8080/cgi-bin/