help_command.txt

exit             Exit Simuino

load <steps>     Load current configuration and
                 create scenario of length <steps>
                 if no parameters, <steps> are as configured

list             List available configurations (max 10). 
                 Selected is marked with '>'

<n>              Select configuration according to number in list

run <steps>      Step until step=<steps>
                 If no steps given - enter Run Mode

loop <loop>      Step until loop <loop>

reset            Reset simulation. Current step set to 0

save  <name>     Save current configuration as <name>
                 If no <name>, saved to current configuration

del   <name>     Delete configuration. If no parameter,
                 current configuration will be deleted.
                 Default configuration cannot be deleted.

add   <...>      Add pin-value-point in scenario
                 Ex. add a 3 100 650
                 Analog Pin 3 will read values 650 
                 from step 100 and forward.

rem   <...>	 Remove pin-value-point in scenario
                 Ex. rem d 7 50
                 Digital Pin 7 will no longer read values
                 specified at step 50	 

info  <area>     Show info about <area>
    - scen       Show scenario data
    - conf       Display configuration
    - loop       Show loop information
    - error      Show Servuino errors
    - g++        Show compilation errors
    - help       Show command information

conf             Show current configuration
conf <par> <val> Edit configuration with commands below:
   - win         Set Window layout mode to <val> (0,1,2,3,4)
   - sketch      Set sketch source file
   - sim <steps> Total steps in simulation