Skip to content

Latest commit

 

History

History
53 lines (43 loc) · 2.85 KB

README.md

File metadata and controls

53 lines (43 loc) · 2.85 KB
Raw

Hubitat Envisalink Integration

Hubitat Envisalink Connection driver and Integration application, provides Hubitat integration with Envisalink. Visit http://www.eyez-on.com/ for more information on Envisalink.

NOTE: the original author of this has left the HE platform, thus this code is not supported. There is another integration which works and is documented here.

Prerequisites

  • Envisalink v3 or v4
  • Hubitat
  • The Envisalink system password that you setup when installing Envisalink.
  • Master Disarming Code
  • The static IP address of the Envisalink device.
  • Knowledge of how the Zones are laid out in your DSC or Vista/Honeywell Alarm system configuration.

At this time, I only support a single partition configuration.

Installation

New App installation:

  • Copy the Envisalink Integration Application URL from here
  • In Hubitat, select Apps Code, New App
  • Click the Import button and paste the URL and click 'Ok' to the warning.
  • Save the file.

Update App to the newest version:

  • In Hubitat, select Apps Code, locate the application to update.
  • Click the Import button - the URL should already exist.
  • Click 'Ok' to the warning.
  • Save the file.

New Driver(s) Installation:

  • Follow the same instructions as above to copy these URL's:
  • In Hubitat, select Drivers Code, New Driver
  • Click the Import button and paste one of the URL's above and click 'Ok' to the warning.
  • Be sure to click 'Save' each time you add or replace the code
  • Do this for 'both' of the drivers above if you have a Glassbreak Device

Update Driver(s) to the newest version:

  • In Hubitat, select Drivers Code, locate the driver to update.
  • Click the Import button - the URL should already exist.
  • Click 'Ok' to the warning.
  • Save the file.

Activate the Application

  • Note: This is only required to be done the 1st time and not required for updates. Removing and re-activating the app will cause your zones to be recreated.
  1. Go to Apps and Add a new User App
  2. Load Envisalink Integration application
  3. Using the Envisalink Integration application, configure your IP, Password and Code to Envisalink and your Zone layout and select which type of Alarm (DSC or Vista/Honeywell).