RF24 Controlled Servo and Motor System

This project demonstrates how to control a servo and motor system wirelessly using RF24 modules, Arduinos, and a pair of transmitters and receivers.

Table of Contents

• Introduction
• Hardware Requirements
• Software Requirements
• Installation

Introduction

This project utilizes two Arduino boards equipped with RF24 modules to wirelessly transmit and receive signals to control a servo and motor system. The transmitter reads analog values from potentiometers or joysticks and sends these values to the receiver, which then controls the servo and motor accordingly.

Hardware Requirements

• 2 x Arduino Uno
• 2 x nRF24L01+ Transceiver Modules
• 2 x Joysticks or Potentiometers
• 1 x Servo Motor
• 2 x DC Motors
• Motor Driver (e.g., L298N)
• Breadboard and Jumper Wires
• Power Supply

Software Requirements

• Arduino IDE
• RF24 Library (available via Arduino Library Manager)
• Servo Library (built-in with Arduino IDE)

Installation

1. Clone the repository:

   git clone https://github.com/DarK404/Car-robot-Nrf24-l298n-.git