Creality Sermoon D1 compatibility #33
Unanswered
ratomas108
asked this question in
Q&A
Replies: 2 comments 10 replies
-
Hello. |
Beta Was this translation helpful? Give feedback.
9 replies
-
But if I have a stock Sermoon d1. The same bin gil would be for all Sermoon d1 printers correct? Then I could just bring up pi or the Creality pad to copy the printer cuff file. Wouldn’t that be the same for ever d1?
On Oct 19, 2022, at 10:41 AM, FeLiXXX81 ***@***.***> wrote:
There is no .bin file for Sermoon-D1 firmware. You can only download configuration file for Sermoon-D1.
After you install klipper you have to create it and then flash your mainboard with created firmware.bin file.
So go and watch how to install klipper for Sermoon-D1 on YouTube and you will see how to do it.
It is 5 minut job when you know how to.
—
Reply to this email directly, view it on GitHub<#33 (reply in thread)>, or unsubscribe<https://github.com/notifications/unsubscribe-auth/AISFPPVEMWTYWGHWRCJ5JJTWEAXGJANCNFSM5W6TFXKA>.
You are receiving this because you commented.Message ID: ***@***.***>
|
Beta Was this translation helpful? Give feedback.
1 reply
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
-
Hello,
I have tried to flash Sermoon D1 display. There is description T5L1 DGUS2 V4.0 2020.12.18 during flashing. Original cfg file contet start with T5LC18. Is it compatible with this firmware? Is it posible to modificate this firmware with DGUS Tools?
Beta Was this translation helpful? Give feedback.
All reactions